I have a Series 1 PTU that was removed from my NA whilst working OK. Also the connector and a small amount of cable is included. Perfect spare...
I have a set of coilpack connectors for sale. $20 free postage sound good? Please email me at andrew.quinn.6@gmail.com as I never remember...
OK cleaning out the last of my Z stuff. Series 1 PTU including harness connectors, brackets etc. Worked fine but removed for Series 2...
Hi All, I am selling my 300ZX due to the arrival of a third child and a company car. Black 5 speed Manual NA Location near Penrith NSW....
When braking softly no problem. Car slows in a straight line. Push the pedal a bit harder and the steering wheel wants to crank to the left...
My lower steering uni has excessive play and needs replacing. Local Auto shops do not know how to find it... Has anyone used any aftermarket...
One of my steering rack end boots is torn and needs replacing. My local Auto shop only has a listing fot Z31 rack boots. Does anyone know...
Well I thought my throu out bearing had failed when I started to hear a ticking sound that went away with slightest clutch pedal pressure......
The outer CV joint on my car needs replacing. I have been told that there is no aftermarket replacement. Reconditioning involves grinding...
My right hand rear drive shaft has a shoddy outer CV joint. Anyone recommend a place to have this repared in Western Sydney? Are second hand...
I have an 89 N/A Manual and need a right hand rear wheel bearing. I have done some searching but could not find anything definitive re part...
Anyone know the function of the black box screwed to the top of the trim panel below the steering column? It has a bunch of wires running to...
I suspect that my thermostat is opening to early, and allowing my N/A Z to run colder than normal. It is not stuck open as there is no flow past...
I am looking to install an Alarm and remote locking to my 89 Jspec. Does anyone have information regarding this installation?? Currently If...
My engine is running like crap (see my other 2 topics...) I have just has reinstalled my injectors after having them cleaned and flow tested....
My car is running on 3 cylinders at the moment, as my other topic. One test I carried out is to install an injector test light that I borrowed...
Sorry for the long post, but I would realy appreciate advice from anyone with good technical insight so please read on... I have just...
OK I know that the correct thing to do when changine a fuel filter is to release system pressure by removing relay and running motor until stall...
What should I use to lubricate my new injector connectors? And where do I get it? I have read silicone grease and dielectric grease. An...
The consensus on this site appears to be that NTK OZA446-E47 is the correct replacement part for the Z32 factory o2 sensor. Why does the NTK...
Separate names with a comma.