Activity stream for all registered members at The Australian 300zx Owners Association.
Ahh I had them flow tested and cleaned I think they were all good.
Issue ended up being the timing 180* degrees out. Got it started!....
I ran into a similar tuning issue as you several years ago. After fitting new Nismo 740's, the engine ran fine when I retuned it to...
Got a little bit further with the altia repairs.
Started by patching the secitons where the light was bleeding through with some Window...
More to add
-Purchased new engine loom / trans loom due to the old one having the consistency of cheese.
-Bde oil filter relocation...
Found some more photos of the ening assembly;
Pre and post the cleaning of the smoo off the turbos.
I ended up getting a parts washer...
Post painting, regasketing etc. Should of painted the balancer but oh well.
Had recently done a major timing service on this motor....
Test fitting in the bay to check clearance etc.
Don't worry the valve covers and plenum are getting painted later.
Decided to replace the water lines with an braided lines from @rob260
Mocking them up;
One of the finished sides ;
Thought id do an update;
Faced with a large amount of issues I was trouble shooting - I thought it was best to pull the motor....
Found some pics on facebook of when the car was resprayed by Alfa Bodyworks in October 2020. That's all I could dig out, probably not...
Separate names with a comma.