Good day all! Well I'm going to give a front bar repair a crack. I have an OEM 2K bar which has a clean split through the bottom of it:...
Good morning all Does anyone have any tips or trick to replace that little fuel hose at the front of the engine under the throttle cable...
Good morning guys, hope you are all well Whilst changing over this little pest of a fuel hose located under the throttle cable: [IMG] I...
So a few Aus300ZX members teamed up with ZClub Australia members and we had a run on the weekend. The result was windy roads, wine tasting,...
Morning all. I thought I would start this off, but I know Chris has some more photos. Jess and I had a great time, thank you to all who...
Hi Peeps I recently replaced my T-Top Hook Finisher and was wondering if it would be beneficial if I put up a how to. I took pics throughout...
Good morning all. I'm just seeking opinions on some 19" Speedy Inferno's My car is yellow which I have found is quite difficult to select...
Morning all I'm trying to strip back the paint from a front bar as to prep for a re-spray. I thought I'd start with an 80 wet, however this...
Hey peep-holes! Just a quick email to all those who have done a heater bypass and not replaced the heater core. I just did it and it's not too...
Wet drivers side, going through coolant like I'm drinking it and the smell of wet anti-freeze dog in the car...me thinks I've done a Heater Core!!...
Just needed to share that with mostly stock goods + a Nistune board Joker hit 204.5rwkw today. The tune was done by Ashley at Classic...
Well. I know I piked out early, but I had the best time! Thx to Wykked and BGTV8 who showed up with their Z32 and Z35 to put on a show, and...
Hi Y'all! "Another fantastic day on the forum with my Zed pals" is what I would have been saying if I hadn't damaged my rear bumper this...
Good morning all! Wondering if any one has any ideas on this one: I have a TT Auto. When driving, if I have to apply moderate to hard...
These are the UAS Ported Manifolds. You can see more info about them on the bottom of THIS page. Pics from UAS website: [IMG] [IMG]...
Okay, here we go guys (n gals)! Sorry for the delay, but I have had a very busy week! This is for an Expression of Interest for a Dyno Day...
Can anyone point me in the direction of some good front bar removal docs, as I have a 2K that I wish to install. I've seen some posts that say...
Comon SA Zed lovers, I've seen a few zed's that look great but have not heard boo out of on the forum. Lets get a thread going, we need to get...
Morning all If there is a piece of the engine bay that has been painted extremely bad and I want to get it back to bare metal, what is the best...
Morning all I was wondering if anyone could point me in the direction of a post or article in regards to cleaning the engine and bay. I have...
Separate names with a comma.