Found this... http://www.turbonator.com/index.html Anybody have experience with this ?
Attached are two pics of my N/A system...In the diagram (coolant pipes 2.jpg)there are a total of 4 little pipes each sticking out of the water...
I've heard that there are numerous coolant hoses under the Plenum that are prone to leaks and many Zeders pass this system. I'd like to do the...
Chewey- got the VDO catalogue and the Low Water Level Alarm Kit is just what I'm looking for (Part No. 170.777). How did you install the probe...
Thanks Chewy for the quick reply i'm searching the Net for a simple probe to see the options. This Water LEVEL sensor and K-Zed's TEMP arning...
thanks I know anout the TWD but I also want a coolant level warning sensor
Hi Chewy I sent you a PM but you may not have seen it. I was referred to you ref. a 'water' (coolant) level sensor that you might have...
have you got a website for this sensor pls ?
how do you plumb it....thro the dip stick hole ? Cheers
Does anyone know how to measure the oil temp using a sensor and gauage, as a back-up system to the coolant temp gauge ?I heard you can do this...
low water level warning kit I enquired but the kit is only for "shop fit" and they don't have instructions for DIY. Anybody know of another...
A beeper sound (high pitched and loud) rigged to the TWD would be a good enhancement. I installed a simple small beeping device on my...
Hi Friends, Pls see below contents of my complaint letter. What would you do ? The Service Manager Honest Motors Ltd 20 Kai Cheung Road...
Thanks ............I'll try that Great tip ! Thanks. No I didn't do that but will pop downstairs and disconnect the battery, it'll be 3 1/2 hrs...
Ran the codes on the ECU using the hightech "Paperclip method" by placing both ends in the IGN and CHK terminals of the Check Connector under the...
Power Hold switch I also wandered and someone else told me on another site (zcar.com)... "Power" is a setting that will downshift more...
sluggish and No Overdrive Thanks for the advice it sounds like you've got the problem sussesd. I'm not a 'good' mechanic and new to this Z so...
When I first start up the Z from cold and drive it the OD doesn't work and the engine is sluggish at slow speed, e.g. from the start when I push...
Separate names with a comma.