as stated car is a Black 1990 2 seater slicktop manual. well loved and maintained car as will be cleary seen upon inspection. thousands of $$...
for sale is a Jim Berry Full Monty Race Clutch that i purchased a while back for an engine build that got cancelled. Clutch is single plate...
Twin pass Front Mount intercooler with all piping, silicone hoses and T-bolt clamps for direct swap from factory sidemounts. everything is...
Greddy Oil Catch can kit for 300zx (or any other car for that matter... its pretty universal) brand new still in box complete with original jap...
as the title says ARP 300ZX L19 Head Bolt Kit VG30DETT studs are brand new still in packets comes with : 16 head studs 16 washers 16 nuts...
sorry guys my internet wasnt goin properly so struggled to get online to sort all this out. heres all the gear i got left. all offers considered....
considering canning my project as circumstances have changed. still on the fence about it. bit over $18k spent in total on all this BRAND NEW...
before i start i will say i have searched and searched and im still clear as mud as to what to do. all the threads are inconclusive and seem to...
anyone know off the top of their head which wires gotta be swapped around to make this work? just like neutral switch?
ive been told that with running larger pistons i should use the NA squirters coz they slightly larger... any thoughts?
i already have a walbro pump and FPCU bypassed. with my new setup i was thinking of running a 2nd one in the tank and twin feeds to the 300deg...
does anybody know what these are for a 1990 auto TT block? or where i would find this? im guessing its probably on the bearings themselves which i...
literally the last bloody thing and then engine is fully pulled apart. have tried everything to get this off with no luck. ideas? ive read a few...
bought these dumps but have since decided to go with a big turbo upgrade and require 5 bolt dump pipes. these are for stock turbo housing. they...
read some older posts about injector sizes, including simons thread a few months ago, and found the results clear as mud. to make it a simpler...
just after peoples experiences here as i know that there is no answer as it all depends what the driver is looking for- top end bang or quicker...
im bout to jump into the TT conversion and only thing im not sure about is ECU. been told u can run an NA ecu with a boost controller in place...
anybody know of anywhere in aus that sells these in polyurethane or of anyone wishing to part with one?
hey i was replacing the window motor and carelessly left it up and the window dropped down and it came off its runners. the issue is that there is...
had an exedy HD clutch put in about 4 months ago. worked fantastic til last week when i noticed that i get a horrible screeching noise when foot...
Separate names with a comma.