Duct tape will fix that.
going to dig this old thread up, seems pointless asking about this in a completely different thread, and before i get shot down for digging it up,...
To add to A2's post check all vacuums, especially the one that goes to the balance bar on the drivers side, make sure you haven't put the water...
when nissan built the 300zx, they raised the engine with sub frame and suspension up to the car, rather than dropping it in from the top. so in...
The helper springs help the main springs stay in place through the full height adjustment range of the coilover. In other words, you cannot drop...
the filter tests shown in post 2 are a bit misleading to be honest. the airfilter isn't to filter ultra fine particles, its to filter large...
starter motor is located on the drivers side of the bell housing on the gear box, and has the Live from the battery connected to the rear of it....
Removing the thermostat will not decrease the pressure in the system if the radiator cap is still on, all it will do is make the engine take...
if you haven't done so already, take the plenum off and do a water bypass, this will leave you with just a few water hoses at the rear and so much...
its annoying hearing everyone say how unreliable the VG30 engine is, when in fact if driven correctly (not ragged) maintained well with all the...
agreed, the coolant bottle only fills up if your coolant is being dumped into it due to high pressure build up that exceeds the radiator cap...
+1 to this For that FMIC DO NOT PLUMB IN LIKE THIS. [IMG] Your pipe work needs to resemble this. [img] Please note how the pipes...
Seriously, how do you miss place the keys to your zed. Anyway, pay for a mobile locksmith, he will be able to make you a new key from the...
what i would of done, is get that cambelt cover off, made enough room by removing the radiator to get a breaker bar with 27mm socket on it on the...
here ya go this might help sticky lifter noise http://www.youtube.com/watch?v=9v_OQaFnb_Y&feature=related bottom end knock...
having heard my own car and what it sounded like just before it did this [IMG] and also fixing it by changing the engine my self as it was...
if it is bottom end bearings like i suspect, then it would be cheaper to buy another N/A engine and drop it in, really not that hard either, looks...
here you go bud Non turbo [IMG] TwinTurbo [IMG] TwinTurbo with boost controller and AIV/EGR/PRVR deletes [IMG] looks more complicated...
the car runs higher revs when its cold, normal idle is around 750, so doubt its about to die on you (with a blown eng cont fuse the car can and...
vacuum leak, have they missed a pipe? or got one connected wrong, once you remove vacuum leaks then start on the more obvious things as mentioned...
Separate names with a comma.
