How freely should these spin when removed from the car?
Can someone who's up to speed with installing timing belts let me know whether these pics indicate an issue, or does it look ok? These pics were...
Is warming the car up to where the needle moves up and is between the pin it usually sits on and the C marker enough? Just did a compression test...
How far down will the O2 sensor snap when you break it? I Have been trying to remove mine using the socket with the slot down the side of it for...
Has anyone seen a writeup on removing the heads with the engine still in the car?
On friday night at Womans and Childrens hospital in Adelaide little Joshua was born. 6 pounds 1. Koroli and I still can`t believe it. Absolutely...
Is there anything else apart from timing belt slipping a notch which would cause the CAS to be fully advanced to set correct timing?
After a long while between drinks we finally had another Z meet in SA on Sunday. I'm not sure on the exact number of cars, but it was definitely...
Ok, update for those following my now legendary cold starting problem story. A few weeks ago I removed the injectors. Noticing that all the...
Just wanted to let the Adelaide guys know about Road & Track Dyno in Enfield. (Atleast for those who don't know about them). Took my injectors...
If injectors have been sitting out of the car for some time, do you need to do anything to them before re-installing them? Can they go bad from...
Just removed my injectors. Check out what I found!! [IMG] [IMG] Only one injector is cracked, but all the seals are screwed! :thumbsup:
What is the best procedure for removing the injectors? Is it easier to remove them while the fuel rail is still on the engine, or would I be...
their fuel pump assembly out of their car at the moment, or a spare they can take a look at?
what I believe is the fuel check valve. Lets air pass right through in both directions with no resistance at all. Does this mean it's screwed?...
I have removed the fuel pump assembly. How can I test the fuel check valve while it's out? Also, where exactly is the valve?
Just wondering whether anyone in Adelaide was planning on going to see Satch play at the Thebarton theatre?
Can anyone tell me what exhaust this is? One thing I did find out today, my cats are gutted! [IMG] [IMG] [IMG] This last pic of the Jasma...
1990 Blue & Silver, 10000km's. Very very clean bike. $4500. Can see pics here:...
What's the cheapest anyone's found this bearing for?
Separate names with a comma.