the reason why i ask is. if you had a dc electric motor (like you have on those electric scooters)powered by ni-cad batteries (which are topped...
this is the port side (alleviates confusion with passenger side ie rhd lhd!)I have been told that these pipes are to help with reaching normal...
what would be wrong with having a greater (water cooled) space between the exhaust and compressor sides of a turbo assembly?
i am trying to learn more by printing some of the html's but cannot get all the page to print, have maximized the margins and even tried...
a completey stripped z32 engine block weighs, and as a short motor, need to determine cold tank capacity.
ecu eprom chip? M105ADA5 12.5V
i did a little research and apparently hydrochloric acid (what concentration? i don't know) is suitable for the engine block (cast steel bits)and...
are the z's vulnerable to sucking up water in flood like conditions?ie air box low and close to ground.
why are there seperate ports on the intake-manifold and plenum? why not make it one big chamber of compressed air?
they are really tight and a 14mm socket does not seem to fit them correctly, is 14mm the right socket? 1/4 whitworth goes close 9/16 a/f is too big.
what do you think about a couple of scoops on the bonnet then vents in the wheel well and then on the guard i quess it will detract from the z...
this most likely has been done before my time. however, any idea who was responsible in the design and development of the z32 1989-2000?they...
can someone please show me how to post a autocad drawing.
what do you think of the idea where a roller bearing is placed into the camshaft lobe ie roller cam?
WHAT WOULD BE WRONG WITH MACHINING A GROOVE IN THE CAMSHAFT JOURNALS, ONE GROOVE FROM THE OIL GALLERY, AND MAKING THE EXHAUST OIL SUPPLY HOLES...
Separate names with a comma.