hi i need some help i have a boost problem. i put the gt45 turbos on my car with external westgage 50mil when i run 12 psi makes same powere as...
hey guys im geting 2x stock 13b rx7 turbos for free, im wondering if it is posible to put the on the 300, and if they would make a big improvement?
hey guys i have a prob when the car hits full or over 9 psi of boost it starts like misfiering but its on and off like sometimes it would go to...
hi will i need a complience plate if i convert from auto to manual gearbox?
sorry guys but i cant find the thred where some one had the simular prob. my car sounds like a wrx when i drive it? what could be the prob?
hey guys im thinking of upgrading my turbos i dont want to do the internals, so would a t28 be good choic or should i go bigger?
hey guys anybody want to come up to willowbank on sat the 15/11/08 i'll be there at about 5pm sorry for short notice.:lame:
hey i just instaled a new asi 56mm rad in my car. everithing was done properly. took the car for a spin came back and parked it in the garage,...
hey guys i want to order new rod bearings but at nissan they need the model number and vin number before thay can order the parts. now i changed...
got done over by asian auto spares:mad: now im thinking of a rebuild. how much do people charge for one? where is the best place to get it done...
#5 Throttle body modification: The throttle body modification isn?t going to be the biggest gain in hp in the world, but the best part is,...
hi i just instaled a menual boost controled was wondering the stock boost gage shows -7 to +7 psi is that per turbo or for both of tham?
hi need thise gone asap [IMG] [IMG] engine has a broken rod apart from that everithing works fine comes with automatic gearbox the...
i need a manual tail shaft all i could find is a non turbo one will it fit on my turbo gearbox?
hi im converting my auto to manual and im pulled the alternator harnes out the automatic one hase this hitachi computer that plugs in same as the...
need some help im just about finish with the auto to manual conversion. now im stuch with the alternator and engine room harness one conector is...
hi im just in the proces for a engin and transmision swap im going from auto to manual. i have pulled the dash out and all the bits and pices...
is it to complicaded to do a auto to manual conversion? i got all the parts needed, will have to pull the old engine as well and put the new one...
want to buy injectors are this any good...
i want to convert my auto to manual so i found this manual half cut for $2500 its a 92 model the engine looks good the harnest looks like new we...
Separate names with a comma.