The rolling shell is gone so everything else plus all the Z spares I have accumulated over 15 years of ownership are going too. A lot of this...
Just found this in storage and u don't want to keep it anymore. $140 pickup. It's the one that used to be in my Z as seen in this video......
I'm packing up all my belongings ready for when I sell the house and there's so many Z parts I'd prefer to sell them than move them. Here's a list...
I'm going to prime a fully rebuilt motor that has sat sealed for about 4 years now and never run. Only oils it's seen has been assembly oils etc....
Selling to make way for the new pipe work. Custom made split bar and plate front mount intercooler. Internally split end tanks made to look one...
Found these while I'm clearing out the study. Comes with full instructions and the correct resistor as well. $50 each + postage. [IMG] [IMG]
Now my driveline is back in the Z, I have a ton of parts I just don't need. Prices are all cheap to get them out of the shed. Original TT...
I built this to allow me to move my Z around while I had the engine and crossmember out. It bolts straight to the same 4 bolts the crossmember...
Saw this on the freeway yesterday. Looked like a big accident. Hope it wasn't anyone on here. [IMG] [IMG]
Hi to all the guys that have coil-over suspension on their cars, or even not on their cars but ready to go on. I'm looking for the main diameter...
Have a few cams to choose from and want to make sure I have the manual cams in the rebuilt heads. Anyone know if they have a serial number or...
Labour: Dismantle & inspect V6 short motor (was given a short block with pistons,rods and oil pump only). Remove crank pulley off crankshaft....
I'm curious at this stage as to if anyone has run a 20" rim on the rear of their Z? I'm looking at a staggered widths and +1" fitting for the show...
Have 2 pairs of TT heads with cams. $500 a pair. 1 x Pair of heads. Missing cam caps. $200 for the pair. 2 x Upper intake maniolds, with...
These come with intake manifold upper and lower, Exhaust manifolds, cams, cam gears. Have looked over them and valve thickness is good. Will...
Just wondering if anyone has this happening on their Zeds? I've found the wire that feeds the horn is also connected to the fog light feeds. I...
Im thinking the Red suede so it would be great if anyone has already installed a set to get advice off. I'm up for just under $2500 including...
[IMG] Am changing the look of the front of the Zed and need to know so I can get one and make the measurements for the next mods. Cheers.
Well I've been pretty absent for the last 18 months or so. Decided to go do other things like travel overseas some more and pursue other things. I...
Pick up from my place in Ridgewood. (just around the corner from Tom at PerthZ in Mindarie) 2 are TT engines complete except for turbos and...
Separate names with a comma.