Hi all, whats the best way to report bad behaviour from a forum member? ie getting ripped off, abused and threatened as a buyer...? cheers
yeah thats what i thought but the volt meter is reflecting 14.1v so it should be sweet..... is it possible my alternator is over charging my...
hey mate, yeah all works well but it does run funny when the aircon has been on for a while on very hot days but i think no zed like the heat ie...
thanks guys, i have since then taken out interior light bulbs both cabin and boot however it still drains my battery. the voltage current is 14.1...
Hi all, having owned by z32tt for almost a decade now, i have been through more than a dozen batteries because it hasnt been my daily so i...
Hi Dave, thanks for the insight however after adjusting idle to your recommended 750 and 850 RPM, my cold start struggles to kick in meaning on...
sychro hey??? ive yet to try that thanks heaps! ive adjusted the crap out of the pedal box, throttle position, clutch master pin and etc.... guess...
hey mate, its a brand new clutch. just done a twin plate back to a single plate, fiddled with it heaps and adjusted it heaps with all new...
hi guys, i keep getting stuck in either 1st or reverse gear usually while parking (on low revs)... car stalls and gear comes out normally...
hey mate, sorry i wasnt clear enough, the above is a list of things i have changed and was wondering if i was missing something, cheers mate
Hi all I have gone from a twin plate os genkin clutch back to a single plate exedy heavy duty clutch, my z is quite standard hence not running...
Hi guys, I'm sure this has been covered before so I'm sorry to waste your time again but how on earth do I install these babies out of sight???...
water thanks mate, i guess i should have been more specific..... im well aware of the clips etc but was curious to see if there was anything else...
hi folks, any tips on installing the 3rd brake light? going for the brazillian look but the piece is quite fragile hence i just wanna double...
ta thanks mate your a legend.....
hi folks, just got myself an aftermarket under pulley but realised the belt sizes are different..... can anyone please tell me what belt sizes...
carrier thanks mate just wat i needed.
Hi Guys, I'm converting my twin plate clutch back to a heavy duty clutch and need to replace my 'thrust bearing carriers', can anyone please...
injectors any chance you got injectors in good condition? if so how much postage to 3073 melbourne? thanks john
cash + lights Hi Jess, will u take $100 + my original tail lights in exchange for your clear lights? cheers johnny ps i can pick up
Separate names with a comma.