Just wondering if anyone has seen the remains of my z at any wrecking yards. I would like to obtain the panel thats between the headlights. I was...
I would like to get another one, but It is going to be hard to replace it. that just just about had every thing it need. It was lower, custom...
Yeah it was a young girl driving and her mum They stopped got there details, it is just really disappionting.
My car is gone, crashed it this afternoon. I am fairly certain it is written off. Had a 4wd change lanes while i was next to it. Spun me off the...
RE The second airflow meter was put on about 5 months ago, I have done 1500km's. It has been untounched since then. I was out on the weekend...
RE The car will turn over it just won't start. That is with the af meter plugged in.
car won't start with airflow meter plugged in will start with plug removed.
Yeah getting error code
My airflow meter has burned out, it is the second one to do it in the last 6 months. Does anyone know a likely cause of this. Maybe harness...
The colour is Actually burning red (nissan 350Z). Done in a three layer pearl, with a special gold pearl. The photos don't actually show the...
Bonnet I did the bonnet myself, They are fibreglass vents I made bonded to the original. The rear reflecter, is in my centre console, the...
It is finally finished, thought I would post a few pictures. [IMG] [IMG] [IMG] [IMG] I took alot of time, effort, stress and...
Kit fittment As I have found cheap fibreglass kits do not fit well, if you want your car to look clean or if you want perfect lines you have to...
just did it code13 temp senser circuit
Mate I just hope that, that glue I am using dosen't sick one to my bonnet
lights and time. I am putting 100mm fog lights in the front of mine, I have made a rubber seal to go around the outside to get a neat fit, the...
Did a vaccum leak test today, there is nothing. If I go to start the engine now it will turn over a only a couple cylinders will fire not enough...
I started my car this arvo to put it away and it started running really rough, hunting alot. If the engine was reved the rpm would lift to about...
more photos The front bar isn't bolted up so the fitment isn't quite there. [IMG] [IMG] This is photos of the bonnet vent excuse the...
Prices. I will make copies if people want them. Basically a front bar will be $650 to make only one. If a few guys want them, say 3 or more the...
Separate names with a comma.