As Silicon chip magazine authors I dabble in microcontrollers and electronics but the guys at this Australian magazine can certainly help you....
i would listen to the guys on this forum. The people on this forum know these cars best. i have used their advice to fix my Z many times. Just...
Check tacho. i assume you have done a visual check of fuel pump connections and ignition components connections. if these check out then when...
Computer diagnostic do not find evey problem. Just a note to ConZult and all computer diagnostics. These are programs and as such respond to...
Aftermarket Intercooler? Are the pipes crossed? Just a thought. Cheking the easy stuff first. Also I would check the Battery Voltage at Idle. I...
Not a problem. No need to feel bad. We are always learning. We are only assisting each other. We were all cluless once. It takes experience and...
Is it Fuel or Spark? i have read all posts so far and I cannot see if you have ascertained whether it is a fuel or spark issue. i suggest some...
a neat trick that helped me. I too had this problem. The Nissan part was very hard to fit. I thought about it and then it dawned on me. I needed...
Did you remove the CTS while checking the ECU wires.... to verify that the 2300 ohms measured is in fact coming from the CTS sensor and not...
Hydrolocked cylinder checked? So when you removed the sparkplug and cranked the engine it was it fuel that was expelled? Is this correct?...
Why did you change the Hose? May i suggest that you may have a done a head gasket and may be the cause of the overheating. i suggest a check of...
Try this. On the odd chance that the too low volts issue is caused by a shoddy earth connection, a test would be to use one jumper lead and...
Is there enough petrol in the tank? I do not mean to be rude but it happened to me because I hardly use my car and forgot when I last put petrol...
Use the FSM to check what is happening I suggest you use the FSM to check the signals and then back trace to find the cause. I suggest you start...
What a mess..................... I gather you bought the car as in the pics. I would do as suggested. Another loom and reinstall. I hope you...
Check the relectors. When I got my Zed I had the same problem. Turned out to be the reflector coating was corroded away. i got them re-coated and...
Try this....... Connect the ground clip to the positive 12V and then connect the tip of the probe to the coil pack connector going to the ECU....
Also here http://www.aus300zx.com/forum/showthread.php?t=333065&highlight=altia MichaelZ
just did a quick search and found this http://www.aus300zx.com/forum/showthread.php?t=332408 There are others. Just search the forum. MichaelZ
We work on old cars because.... of the pleasures like the satisfaction of solving a problem yourself and also saving you money and learning...
Separate names with a comma.
