Yes, WIP but for NA. To say the least. Inlet pipework just the tip of the iceberg IMO. BTW #4 cylinder exhaust flange requires...
Did any Z32 come out with a spare tyre well for a "normal" size tyre???
This pours on with very low viscosity filling cracks. Sets quickly (1/2hr) and is very strong (You can make tools with it). Similar material to...
734-08-BLK Block (M18x1.5) to Oil Filter (3/4x16) [IMG]
Possible faulty air regulator.
[IMG] Yes should all fit except headers and dump pipes. If you see here, I think all other sections have the same part numbers....
Looking for the easiest most cost effective way of: A/ Fitting the pre '90 DE(T) intake plenum onto the post '90 DE(TT)? [IMG] B/...
But I reckon if you can fit a tree, you can fit a re-locator. Just you would probably need an M18x1.5 to 3/4"x16 adapter. And remove half the...
Sorry can't be bothered. Not feeling too well. :D:D:D Also when mounting your lines and cooler etc. I have been told to make sure you keep them...
Another alternative would be to run an Oil Filter "Re-locator" straight into the block and mount the filter elsewhere???
Be careful when buying an NA filter tree that it is actually from an NA. My NA has a filter tree more like the that on the TT but it is cast...
If you change out the center adapter in the block (Unscrews). You can go straight into the block with the oil filter. I would double check for...
Thanks, will do. Still need a third Brake Lens / Infil by the way. Converting to F40 rear wing. At this stage engine bay is completely...
Separate names with a comma.