Hi all, whats the best way to report bad behaviour from a forum member? ie getting ripped off, abused and threatened as a buyer...? cheers
Hi all, having owned by z32tt for almost a decade now, i have been through more than a dozen batteries because it hasnt been my daily so i...
hi guys, i keep getting stuck in either 1st or reverse gear usually while parking (on low revs)... car stalls and gear comes out normally...
Hi all I have gone from a twin plate os genkin clutch back to a single plate exedy heavy duty clutch, my z is quite standard hence not running...
Hi guys, I'm sure this has been covered before so I'm sorry to waste your time again but how on earth do I install these babies out of sight???...
hi folks, any tips on installing the 3rd brake light? going for the brazillian look but the piece is quite fragile hence i just wanna double...
hi folks, just got myself an aftermarket under pulley but realised the belt sizes are different..... can anyone please tell me what belt sizes...
Hi Guys, I'm converting my twin plate clutch back to a heavy duty clutch and need to replace my 'thrust bearing carriers', can anyone please...
hi guys, just installed my ptu 2 and my z still wont start (didnt crank over initially) any do's and dont's or pics of how the ptu 2 should...
wats the cause of wet spark plugs and wats the best way to fix it without the obvious of having to change them as mine are still fairly new?
i changed my fuel line to braided ones, changed vacum line, changed fuel filter, installed a front strut brace and now my engine just cranks over...
attempting to get braided fuel lines made up, what lengths do i need and is there anything else i need to know? ta
wanting to change my hand brake handle (not boot), but im having trouble doing so as i cant take the old handle off. is there a specific way to do...
silly question: wat is the best way to thread through my throttle cable and fuel lines through the brackets of a front strut brace?
would it work on a tt?
speedo initially worked only when travelling above 80km, then soldered my speedo and was working but needed to be calibrated, then wounded back...
have soldered back of my speedo, it works but i think it now needs to be calibrated. when travelling 60 (as indicated by speedo) its actually...
how do u remove and shave a fan shroud? and what difference does a ptu 2 do for the car?
would changing the bulbs behind the cluster be the best way to brighten up my tt dash? it currently looks dull and off white. i just installed...
hi folks, does anyone know whats the best way to install gauge rings? ps i have limited tools and experience cheers
Separate names with a comma.