Thanks for the input all. I have managed to sync the butterflies. But need to readjust the stop screws. The idle is rock solid now, but too...
Well its all adjusted now. Have both sitting at the same spot open and closed. Needed to synchronise it a little. Probably have to mess around...
I don't think the cross linkage is causing any issue. They appear to be synchronised when fully open, I've measured it as well and they're both in...
Hi all, I took my intake piping off my TT today to clean the throttle bodies and after doing so I've noticed that the butterflies are not in the...
FIXED! I replaced my dimmer relay today and my low beams came back to life :D Wasted some dosh trying the high beam switch first but in the end...
I'm a bit of an electrical noob, which ground wire and where is it I should be testing? Or just disconnect a low beam bulb and test from there? I...
Also the picture above where it looks like the fog lights are on, I can actually turn on the fog lights in addition and they get brighter in that...
Replaced the high beam/indicator switch. The dimmer relay appears to work in some capacity, as when the lights are off entirely I can flash the...
Finally got a new switch in the post. And nope, not the problem. Incorrect diagnosis I guess, or this switch is stuffed as well... Anyone got...
Update: I replaced the Clearance Illumi fuse, no effect. This is what my lights look like on: [IMG] So yeah only the highbeams are on but...
The clearance illumi fuse? 10A one in the foot well right? I checked that and it's fine. I'll replace it with one of the spares in there and see...
Yeah true, thats a great idea. I'll try using another relay. The low beams use the projectors on the sides yeah? Sorry for the nooby question...
Hi all I've done a whole bunch of searching already but haven't come accross my exact issue. Whenever I turn on my lights its in high beam mode...
Get a volt meter and test your TPS. Follow this method: http://z32.wikispaces.com/Throttle+Position+Sensor Does your check engine light...
Just a little more info for you on TPS readings, since I last posted in this thread I have done tests and replacement on mine. I noticed a spike...
+1 for some kind of obstruction stopping the socket from reaching. I doubt a threaded plug would feel the same resistance turning boths ways. Also...
Yeah you're right. I should bust out the multimeter on all those pesky sensors. I think my next step is cleaning the plugs at the very least....
Running 1 bar. I guess I'll just need to fork out for some kind of programable one and get it dyno tuned. Also now I think about it the issues...
Hi all, I fixed my hesitation issues by replacing my TPS but now thanks to the increased responsiveness its uncovered a hidden miss when its cold,...
After 50km of testing have had no issues with the new TPS installed! Almost had me Nissan, almost. 300ZX:0 Me:1 :br:
Separate names with a comma.
