I have new rear lower arm bushings to install. These appear to be the only ones that are directional as they are flanged on one side. Can't...
So I just found this part floating around my engine bay. Was resting in between the crossmember and the steering rack. Anybody know what it is...
I am in the process of doing my 100k service and have discovered a worse than expected power steering leak. I knew there was a bit of a leak and...
Or something more sinister? In the process of doing my 100k service and with the lower cover off there is quite a bit of oil and muck. Does this...
Hi, Got new tyres yesterday and had planned for an alignment too but the bloke doing it said the drivers side tie rod end at the front is stuffed...
The latch on my hatch had become slightly loose and was causing a rattle when going over bumps. Tried to adjust it and had it better but it very...
Have been collecting quotes to get my exhaust replaced as it is on it's last legs. Just went down to Exhaust Technology (for those interstaters...
Back in early september my car started to make a shocking noise. With much to do, and no real requirement upon me having the car on the road, I...
Car is making a horrible noise on decelleration. Sounds like it is coming from the drivers side turbo region. The first sound clip is from above...
from the group by which is 2.5"? And will there be any benefit in going to only 2.25" front and dump pipes?, seeing as they are already around...
Mine is GONE. No idea how that happened but I'm getting the awful starter grind noise and I need to get it reconditioned. Probably no point...
I'm a bit confused when it comes to getting larger wheels. If you go up in wheel sizing, obviously your tyre size (sidewall height) needs to go...
Called all the wreckers in SA with no luck. Also tried Cresta. Unfortunately no-one has one. The price from Nissan is also apparently quite...
Or anyone know where they can be aquired cheaply/ second hand? Damn nice mags, damned expensive
I'm sure you all know that the Diablo has the same headlights as the 300zx, except for having a small carbon fibre strip across the top....
Put the new brake pads (bendix ultimates) and machined rotors on last night, and the bearing in today. Set a new personal record from time of...
I had my thrust bearing go early December. Replaced that along with spigot bushing, clutch and rear main seal. Been on the road just 2 months...
Needed to change thrust bearing so gearbox etc out. Came across a bit of a problem (i think) when having a look in there. It would seem tehe...
Test your knowledge here (oh and your rice status). Click Here I got Racer X (cheering, i THINK that means i have zero rice value) Post...
OK, here's the deal. Started developing a strange noise on Friday night, was gone Saturday. Didn't drive Sunday. Drove this morning and it was...
Separate names with a comma.