How freely should these spin when removed from the car?
I was just about to pull the engine so that I can remove my heads. How have you found doing it with the engine in? Do you have the drivers side...
Cheers for the help guys.... Craig, I had it happen to me once before too, but that was because the spline between my exhaust cam and CAS was...
Yeah sorry, I should have explained that. CAS has to be set there to get a reading of 15degress with timing light when warm. I agree, it's...
Can someone who's up to speed with installing timing belts let me know whether these pics indicate an issue, or does it look ok? These pics were...
Possibly PCV valves They are known to cause stalling when braking to a stop if the springs in them aren't working as well as they used to. Also...
Yep, have done all that tried swapping coil packs and that's ok, and there is power and pulse going to the coil pack. Also the injector is...
Is warming the car up to where the needle moves up and is between the pin it usually sits on and the C marker enough? Just did a compression test...
How far down will the O2 sensor snap when you break it? I Have been trying to remove mine using the socket with the slot down the side of it for...
I remember Blade..... who was on the forum a couple years ago from Queensland, quite a character..... lol Apparently his plan was to build a Z...
The lower injector insulator set (PN# 16635-10V10) is what the fuel rail sits in. You will probably want to get a set of these. The upper O-ring...
Separate names with a comma.