Hey everyone... I am having a clutch issue that I cannot pin down, and, as always, when I can't get an answer on the american boards, I look...
Bet you've never seen this one... I just put the cruise control back on after doing the LS swap last year. When I took it off, it worked fine....
[IMG] [IMG] [IMG] So I got the vents in, sorta. I need to secure them, but I want to wait for my rattle can paint job on them to cure for a...
Hey guys... I recently got my fuel vapor issue at the tank fixed thanks to a new Oring, and a couple new pieces of hose on the tank. Since...
Hi guys... I stumbled on a thread here a long time ago about this topic. Someone posted that there is a seal that goes under the insert in the...
Hello from the States! So, 6 hours ago, this was just a long block, but I made some good progess today. I finally got the motor back a couple...
Hey guys... do any of you know of, or have you experienced the FPCU fail on just one of it's three "stages?" Like the second step for example?...
Hey guys... I will admit, when I first started messing with these cars, I used to struggle like hell, and always needed help getting the...
Hey guys... Just wanted to say that if any of you are considering using any of their products, do not hesitate. They are a great company with...
Damn... got the car running again, seems to be coming along, up to about 17-18 in of vacuum at idle, so the rings are seating. Then...
So... After the incident of incredible stupidity on my part, I took the motor back out last weekend and got it tore down. I ended up...
Hey guys... After my screw up with the new rings on my car, I don't want to go through this crap again. I want the rings to seat in right....
And shit compression... I guess the rings aren't seating. 1: 95 2:100 3:90 4:90 5:120 6:100 the plugs look great. Much better than...
Hey guys... greetings from the U.S. Hope all is well. I am posting here because I got no answers on the US Z boards I frequent. Before I...
Hey guys.... TT.net is down, and i was in hopes of hearing from someone who really knows their stuff with really high flow/high hp motors....
Separate names with a comma.