Single turbo zed

going to try squeeze cooler here
will relocate relocated relay box

 

im geussing the tow hooks are getting to meet with the grinder as well lol.....

looking pretty awesome so far i must say!

 

i can push it back past them

 

you should really have the pipe entries facing the motor like mine .. easier and shorter piping

 

yea true but the plan is to use the stock pipes

 

fair enough

 

only because if i make a kit there will be less for me to make

 

I did mine from mild. This is an early fitup.



E

 

where did you get all that room

 

Errrrmmm.. what?? Room for this perhaps???.....:



TeeHee

 

Now THIS is cockswinging!!!!!!!!!

 

Stock boost hahahha come on evan pump that shit

 

Heheheh stock injectors = stock boost!!!! for NOW!!!!!

E

 

sooooo done up a rough drivers side mani today
need to go get a flex and some 3 bolt flanges to finish it off
making collector was cool. drew it up in solidworks then turned into sheetmetal and printed out a flat pattern.

 

Very nice collector, pretty much the same as the 6boost ones.

 

yea piece of cake to make ay. might make a few and sell em

 

The manifold looks good.



Have you seen the iceengineworks exhaust modeling system?

If you do a lot of one off design it may be worth the investment.

 

for the price they ask for this stuff not worth it ay. i find it nice and quick to just get in and do it. to make that drivers side it took 2.5 hours to get to where it is now. i have to pull apart to weld then put back together again but its not really that hard to do.
they would be awesome if you were doing a Ti system though, do it once do it right.

 

bit more to go and shes all done