The part which is screwed to the B pillar, the roller on mine is worn and sloppy, need a tight one. Said the Bishop to.......... PM good. would...
Brake place says there are no rebuild parts available so is there an alternative booster available new or for which parts are available ? Did a...
Highest ratio/lowest number I've seen is 3.57 but I'm looking for one around 3.00. Is there such a beast?
'87 turbo, does not seem to be anything around other than the Z32 conversion which is too small for my purpose, need something up to 300 mm.
Jatco RE4R03, have spent hours searching everywhere and no can find a definitive dry weight:confused: Am desperate, may gift selected body parts...
Refurbished by JB, 3600 lbs clamp, weighs 14.5kg total, negligible wear on the metallic facings. Has been sitting around for a while so some minor...
Had this crank nitrided, plugged and balanced by Crankshaft Engineering, Brisbane, for a race engine but the builder didn't clean out the block...
Exedy sprung twin plate clutch, includes lightweight flywheel. This is a great clutch, no measureable wear, has a cool sounding but mild rattle...
1. set Tomei Poncams suit non VVT, excellent condition - $950.00 2. set oversize Wiseco 8.5:1 forged coated pistons on Eagle rods, some marks...
The wobblely shift link out the back of the gearbox, could someone with a gearbox measure the link pin to link pin centres please? I have a...
Anyone doing this? Entries can only be made by members of the NSWRRC and Porka NSW club and close Friday I think. CAMS won't allow sprints at Mt...
PPG, Albins and Hollinger don't list anything, looking to lower 5th from .75 to say .85 because .75 is too high for the track. Accelerates nicely...
To the experienced blokes, what diff ratio would you recommend? Aim is to just hit 7000rpm at the end of the main straight, in 5th gear of course....
And to replace one back in the car too. Just an average time with one person on the job and no hoist or pit.
Have a choice of two pulleys, one is 120mm in diameter, the other 126. With a Ross crank pulley which wp pulley would be best for a 7000rpm...
What are these clutches like to use? Assuming they are fine for competition use, what are they like in traffic, both in take up and when they have...
Anyone had experience with these? Good? Bad?
OS.Giken or Exedy? I understand that any twin plate will rattle with the clutch in but otherwise? Z is a weekender, some road driving but mostly...
Present one is a 3600 pound single plate Jim Berry special pictured below. Looking at some incar sprint circuit videos it seems like it may have...
The All Japanese Day is on again on the 19th of June 2011, it looks like it will be the biggest dispay day yet. Last February's All Classic...
Separate names with a comma.