Balance pipe worked for me.... Had a new exhaust built, asked them to add a balance pipe, as previously it had gone through an common muffler....
Forward facing Forward facing is fine - rear facing just doesn't really fit..... When the car was complied it should have had child seat anchors...
Have you double checked the firing order? Sounds like you have swapped the leads round so its running on 4 - but igniting some mixture with the...
MPH? :cool: one of the trips I want to do...probably need to swap back to the TT rear end though LOL
I've done it before - need to use the TT torque converter and flexplate otherwise the starter won't engage on the flexplate (could possibly swap...
Pulled the lower plenum off - to find a M12 x 1.25 tapped hole there? Not sure why as I would put money on it that the lower plenum hadn't been...
:worthless: *VIDEO :br:
Cheers - about what I thought then. Time to get the lower plenum of and size up the drill and tap
Started doing an oil change on Sunday, which turned into pulling the lower plenum to install a 2nd det sensor for the knock lite I recently...
NA rear is the best bang for buck performance mod in a TT bar boost jets.... 1st gear is a bit short - but in the rest of the gears its...
Yup - I struggle big time with axle tramp if I'm not sideways.... Tried that and broke a half shaft due to the axle tramp! :o But on the...
Check the tech section - you either need to de-vein the rotor, or you can remove the pressure valve (ball bearing and spring) and loop the feed....
Flex plate and converter are different - larger converter on the TT, different output shaft size and spline count (can swap to match the front...
As per everyone elses comments - you will need the computer and switches as well - rather than the stock buttons / steeringwheel setup - CZP are...
Separate names with a comma.