On the drivers' side of the plenum there is the EGR actuation valve with three pipes coming off it. Pull the three pipes off and block them off...
Hope you do your promised tech article on your job as I might be doing my sump soon :( Thanks.
Great project - hope it goes forward as there are a lot of old tired engines that wil soon need attention (including my own) and although...
I'm not sure how you are identifying a vacuum leak while the engine is running so perhaps you have already pressurised the system and hearing...
Welcome back John. Should have remembered your name as I know a John Jansen over here (he used to play for the Dragons many years ago) but I had...
Yes - and I am VERY surprised that a couple of the most knowledgeable members on this forum take the opposite view. Blocking off the hard...
In addition to the places mentioned you could also try FX Larkin - they sell "stuff" fairly cheap.
They are not interchangeable - people put NA pumps on TT's when they remove their HICAS. You can alter a TT pump to act as an NA pump but why...
The thread on your car where the oil pressure sender screws in is 1/4 inch BSP (British Standard Pipe). Perhaps the thread on your new sender...
As I understand it with regards to the earlier models there is no central locking module. There is an actuator on the passengers' side door...
Yes my Aus manual has it as you are suggesting although this information is on page EL-71.
Somebody had a problem like this a while back and they found that there was something under the tensioner mounting surface putting the...
You have pre-March 1990 rear wheel bearings that don't have the out-rigger on them. After March 1990 they came with the out-rigger like the...
MY GOD!! Flexing what??!! :eek: :eek: :D:D
If you have an NA be careful as the bearings prior to March 1990 are different to those afterwards. The bearings prior to that date don't have...
Separate names with a comma.