sooo thinking of ging RB in my car, rom what i can tell a RB25 bellhousing will bolt on?? also the remote shifter, it looks like i can bolt a standar RB shifter onto the box and plug the remote hole? Ryan
i dont have a zed remember, i just want to turn my z32 manual box into a rb25 box, possible? dont worry about the politics
whats an adapter worth? if its too much trouble ill just sell the zed box andbuy a 25 box, i figured if i could through a RB bell housing on and change the shifter it would be a 25 box, reason id bother is because my box is mint and i wouldnt trust another box as much as mine, 350-400hp max
mint, what about the shifter? it looks like its tranferable, mind you i actually wouldnt mind the shifter being a bit closer to the seat
should be ably to remove the remote mount and put the rb shifter in. or just shorten up the remote mount a few inches. been reading and you might be able to just swap all the internals over
Nothing to do with ratios at all, and the ratios are exactly the same. They have the same internals The RB25 MT front bellhousing can be bolted to the Z32 MT rear half so he wouldn't need to fabricate an adapter plate, and can use existing gearbox mount and driveshaft...
well actually no, i dont thinki so, in my car the VG is about 150mm from the fire wall. if i was to put a rb in the rear would be close to on the fire wall. pushing the box back 150mm, hence the reason i want to use a rb25 shifter also, as the shifter will move back 150mm also. and my shaft will need to be shortend