z31 question

Discussion in 'Technical' started by Zed31, May 29, 2007.

  1. Zed31

    Zed31 Ron Burgandy

    does anyone know a workshop in SEQ thats worked on and modified z31s?
     
  2. d3c0y

    d3c0y Member

    how modified is your z31 - what do you want done? they arent very hard to work on
     
  3. Zed31

    Zed31 Ron Burgandy

    no mods. and its not so f**n easy when u hav no idea about the electronic stuff. not to mention the fact that if i touch anythin im afraid it will blow up!!! well, not that extreme. but still, i AM paranoid ill stuff up. and the electronics/ECU side scares me :p
     
  4. d3c0y

    d3c0y Member

    so you didnt answer the second part of my question - what are you getting done.

    You will get more responses to your question if you dont just say general stuff.

    Say i want to get a boost controller installed on my Z31 i want to know where in brisbane etc ... or something like that
     
  5. Zed31

    Zed31 Ron Burgandy

    i want to know where in brisbane i can get someone to install

    -FMIC
    -boost controller
    -fuel pump (z32 tt)
    -injectors (bosch/nismo 550/555)
    and associated ecu work/engine build
    ....maybe a new turbo :D

    on a Z31 turbo.

    p.s. without the turbo upgrade, what kind of power can i expect from these mods? ive been told the stock t3 unit runs out of puff after 360-380hp
     
  6. 260DET

    260DET Active Member

    If you after a fair bit more power, it sounds like you are, then I'd be looking at a good aftermarket ECU for a start. Once that is done then you can plan specific mods.

    Going to cost you though, there is little specifically avilable for the Z31 too, even in the US.
     
  7. rob260

    rob260 Administrator Staff Member

Share This Page