Willowbank Test n Tune 14/5/08

Discussion in 'Post Event Discussion' started by pmack, May 14, 2008.

  1. pmack

    pmack Member

    Thanks

    That was on street tyre's
     
  2. BurgerZ

    BurgerZ Banned

    awesome job mate

    the numbers just dont make sense ;)

    60ft time isnt quick, and the trap speed isnt either. So how does it work lol
     
  3. 300zxt

    300zxt Well-Known Member

    Transbrake auto time, they'll clean those numbers up for ya! :) Sweet run none the less...
     
  4. pmack

    pmack Member

    New p.b 12.71 @ 110.8mph 178.33klm

    I went back to willowbank tonight armed with a shift kit that works! (finally) Nice cold night ,car improved slightly on every run , still have slow sixty foot times (wheelspin street tyres) I will send the time slip to Peter (fleet).
     
  5. Fleet

    Fleet Speed Racer

    man thats going bloody quick!!

    what mods do you have?
     
  6. Chad_

    Chad_ Well-Known Member

    awsome work man. what was your 60ft this time? you say you are going into wheelspin mode on the launches? what are you stalling it up to? how much boost are you building?? check out my launch vid in my sig. you are prob stalling it up too much?
     
  7. pmack

    pmack Member

    Surprisingly few mods

    A fleet supplied apexi pod , fmic ,12.5psi ,safc , superior shift kit(auto) , udp, rear mufflers 2.25 inch, thats pretty much it, Something i will have to do before i run it again is remove the speed limiter, im hitting that at the end of the track .
     
  8. pmack

    pmack Member

    first yellow light i floor it with the brakes on hard as possible

    And sometimes they hold ,:) need some sticky tyres !
     
  9. heavytrevy

    heavytrevy "Hammer time "

    Great time for the mods:thumbup:
    should be able to cut a few tenths off that with some sticky tyres and limiter removed :zlove: :zlove:

    Regards
    Trev
     
  10. ed300zx

    ed300zx Active Member

    2nd, with some micky ts on the back you SHOULD see 12.5s
     
  11. Chad_

    Chad_ Well-Known Member

    what do you mean? so you just press on the breaks and just keep stalling it up to what?

    try pumping on the breaks first. keep pumping them untill it gets harder and then hold it...

    what was your 60ft time on this run???
     

Share This Page