you have a n/a so go to the plenum and pull the black things off the front and put aero start down the intake by opening the butterflies and let some aero right in then shut butterfly no accelerator and it should fire and then start up
yeah its a twin turbo i took the front little grill off where the z badge is and the air intake there thats where i sprayed the aero in and still nothing. was that where i was ment to spray it . ? is they anyother way to do it . ? or get this car to at least fire up. iv done everthing . put change ecu or ptu as a few of the member's on here have told me to do that .
No, you don't spray it there. You spray it directly into the throttle bodies. I take it you've started the process of elimination? No ECU faults, spark, fuel, compression etc...
No in the engine bay there is a plenum 6 legged spider looking thing on drivers side just undo the big fat pipe that runs to the throttle part open the throttle with help if needed a butterfly thing that opens and shuts with throttle going up and down spray aero in when open shut and try to start
you shouldn't need areostart or anything like that to start ya car ay. have you checked your cas plug? pull a coilpack out and put an old plug in it and crank it to see if your getting spark. make sure your cas plug is nice and clean to
The pic at the top. See the two top blue silicone couplers that is where the throttle bodies are. But as Ezzupturbo said you shouldn't need to use it to start the car.
