here is a video of cyl 2 its not firing im wondering what this is i used a little screwdriver thingy that lights up when power is running through and power is not going through on connection its the one with the green thingy. cheers jamie http://img594.imageshack.us/img594/8241/img2211d.jpg [url]http://img28.imageshack.us/img28/9826/vkye.mp4[/url] http://img546.imageshack.us/img546/724/a2m.mp4
Worked but... ...i had to use right click and open with menu, then it found Media Player after it downloaded/buffered, and ran! Is it just the way it recorded or have you got a sticky lifter in there somewhere?
im not sure im going to take it to someone soon im just a little busy how would i check for a sticky lifter??
Lifters are just a noise thing at this juncture. you have bigger fish to fry at the moment. You've got an intermittant wiring issue on that cylinder #2. Go thru the motions of checking continuity between the PTU and the coilpack wiring and the earths. Red/white wire shoudl show continuity to the PTU Red/white wire (assuming S1 ptu is still installed). Middle black wire goes to the Ignition coil relay Black wire. Right side wire goes to the black(earth) wire on the PTU. Get a multimeter on it, set to continuity. Should beep. Wiggle individual wires and see which one loses continuity. Replace as needed or run a new wire to bypass it.
yeh i think its s1 im going to swap to s2 its the black wire on the right how would i replace the wire or bypass it??
Cut it at one end and the other, solder a new wire in its place. Either incorporate it into the loom, or run it along the loom and tape it in place. Then crack a beer. You deserve it after a sold 5 minutes work on the Z :zlove:
would anyone in brisbane care to come help with this as my car is unregistered and has a saftey wheel on it will be supyling a case of beer ( your choice ) and some lunch or dinner depending on the time ( im a chef ) any help would be greatly appreciated i had a look at it today and i was so lost it felt like i took a wrong turn in Albuquerque. if anyone would like to help me out i would be extremely grateful just pm me also it would be great to meet another Z enthusiast cheers jamie
