Shed cleanout, various parts (VIC)

Discussion in 'Car Parts for Sale or Wanted' started by LaZZaR, Apr 13, 2008.

  1. LaZZaR

    LaZZaR Member

    The Zed is going, so time to clean out the shed! Prices exclude postage. Items are located in Berwick, Victoria. PM me if interested.

    Please excuse the quality of some of the pics, they were taken just as it started to rain.

    Techtom CMX100
    Useful little unit, will display Speed, AFM voltage, Injector duty cycle and Engine temperature. Has peak hold function. This is the US model so the speed is in MPH and temperature in farenheit. Plugs into Consult port, self powered. Kept it plugged in all the time during summer to keep an eye on engine temp, much more accurate than the stock temp gauge!. Excellent condition, complete with box, $150
    [​IMG]


    Tail lights
    Top set are in almost mint condition, $100 for the set
    Middle set are preety average, some small cracks and general wear around the edges. $50 for the set.
    Bottom one (Left only) has tint spray on it, average condition, could use for experimentation. $20.
    [​IMG]


    Rear centre panels
    Both in reasonably good nick. $35 each
    [​IMG]


    Stillen leuvered nose panel (Genuine Stillen)
    Black, some paint has chipped off, but in otherwise good condition. Cost $300 new... selling $180.
    [​IMG]
    [​IMG]


    TTZed hose clamps, set of 8
    Brand new, never used. $25
    [​IMG]


    Koyo 50mm Radiator, with stainless steel bracket
    Brand new, still shrink wrapped, complete with box. Will come with brand new stainless steel bracket which goes over the top, replacing the stock brackets (not pictured). $550 for both.
    [​IMG]


    Caz Racing lower radiator hard pipe
    Brand new, with silicon hoses and clamps. $80


    Mines ECU (chip only) and brass plaque.
    For Twin turbo. Chip removed from one of the Mines edition 300zx's. Never got round to fitting it. I've been told that it would suit cars at stage 4 to 6, but you could probably tune to suit whatever you want. $200.


    Upper and lower intake plenum
    Nothing wrong with them, was going to be my polishing project. I believe the throttle bodies are still attached, but I will have to confirm this. $100 for both.


    ZID imobiliser, as manufactured by Zed4life
    I've got two of these, both never used. Do some forum searches if you don't know what these are, or see zedcare.com. Installation instructions will be supplied. Brilliant little device, short of towing the car, it makes stealing the car VERY difficult. $70 each.
     
    Last edited: Apr 13, 2008
  2. kaos Z

    kaos Z New Member

    pm sent....

    N/M
     
  3. BoneZx

    BoneZx Active Member

    zid is mine

    i'll take the zid. pm me you details plz
     
  4. Anton

    Anton New Member

    what size are the hose clamps?
     
  5. LaZZaR

    LaZZaR Member

    MORE STUFF

    Boost leak tester
    As new. $50
    [​IMG]


    Boost controllers
    Top one is old style Turbo Smart, dual stage. Requires a switch and 12v to switch boost level. $80
    Bottom one is a generic bleeder type. $20
    [​IMG]



    Temp sensors
    Left one is coolant sensor for ECU. Brand new, never used. $30
    Right one is coolant sensor for the temp gauge. Brand New, never used $20
    [​IMG]



    Brake Master brace
    From the "Chilli" GB some time ago. Brand new, never used. Design allows use of strut brace. $50
    [​IMG]


    Axxis Combat Shift Indicator
    Formula 1 style shift light, LED's light up in sequence according to RPM. Have modified the LEDs to be Blue, Green, Orange, Red, rather than all red, so its easier to distinguish RPM out of the corner of your eye. Fully adjustable for RPM range, can set both the low and high range, or you can have them light up all at once. No wiring required, just plug it in, compatible with 4, 6 and 8 cylinder engines. $100
    [​IMG]
     
    Last edited: Apr 13, 2008
  6. tHeSmUrF

    tHeSmUrF tHeSmUrF

    PM sent

    re the sensors, clamps, brace and koyo radiator.

    Cheers
    Mark
     
  7. Kabir

    Kabir Well-Known Member

    sensors

    DIBBS on sensors if Mark doesn't want them.

     
  8. heavytrevy

    heavytrevy "Hammer time "

    Dibs on the best conditon rear panel :D

    Regards
    Trev
     
  9. LaZZaR

    LaZZaR Member

    PM me (n/t)

    n/t
     
  10. mark

    mark mark

    center panel

    can you call me regarding this on0439926924,thanks mark.
     
  11. jaja101

    jaja101 New Member

    Tail lights

    interested in the best condition ones~
    How much postage to Perth WA?

    Jeff
     
  12. ADAMZX

    ADAMZX 2000spec Conversion

    Interested in nose panel. Im guessing from the look its fibre glass nose?? Whats its condition eg is the paint just cracked off or is the nose damage in that section? How long have you had the nose for too???
     
    Last edited: Apr 14, 2008
  13. Peter Black

    Peter Black Active Member

    Definitely interested in the radiator hard pipe, PM on it's way.
     
  14. ZXDEVIL

    ZXDEVIL Active Member

    You've got pm
     
  15. AK300ZX-TT

    AK300ZX-TT Won 5 Autosalon Awards 08

    pm

    did u get my private pm about the clamps mate,
    that i would take them 4 sure
     
  16. badxtc

    badxtc kirby's bitch

    p.m sent for radiator ,,, if not sold ill take it .......
     
  17. deZed

    deZed Member

    PM sent

    For ZID and brace.
     
  18. LaZZaR

    LaZZaR Member

    UPDATE

    All items below are sold pending payment

    CMX-100
    Temp sensors
    Both ZIDs
    Radiator
    Clamps
    Chilli brace
     
  19. LaZZaR

    LaZZaR Member

    It will be somewhere around $30 - $40
     
  20. LaZZaR

    LaZZaR Member

    Yes its fibre glass.
    No damage to the panel itself, its just a bit of the paint which has chipped off, which you can see on the leuveres on the right.

    I think i've had this since around mid 2003, purchased in this exact condition and has been wrapped in bubble wrap and stored in the shed ever since. Was going to get it resprayed when I got a 2000 spec bar, which never eventuated :(

    PM me if interested
     

Share This Page