When installing intake pod filter, i seem to have damage/lost one of the rubber things which hold the nose panel flush with the front bumper. now it is not fitting right. Does any one know where i can get a new set? I am very perdantic and not having the nose panel looking perfect s**ts me.
I know you can get the whole set from caz, http://www.cazracing.com.au/catalog/product_info.php?cPath=45&products_id=266 Not sure if you are after all that, have no idea where youd buy them separately.
haha yer some difference. filter box is a bitch. wasnt prepared to risk taking off the front bumper becuase have had that much exp with z32 so tried as much to do it without removing the bar. One side was unscrwed already :S So time for spartan force....FOR SPARTAAAA!!!! out it came. It is installed with a Calibre piping and waiting for custom made intake pipe.
Most zed's seem to have had some altercation with the front, so the front end usually is a little bit warped. It shows up in the bonnet alignment and nose panel alignment. I have several washers on the left side on silver's nose and I have been sitting on the bonnet with a 4x2 in the middle on the convertible trying to line things up
Almost every second hand nose panel sold in here would come without any of the seals or brackets. With the number of Zeds being dismantled you would think there would be more about. However, if you can't find any but really want a couple, then ---> http://www.conceptzperformance.com/..._Type=NIS300&UID=20090522022746203.166.87.114 Probably cost prohibitive from a postage point of view - but if no-one else you know in WA is placing an order with Coz, I will be in the next 2 weeks, and could get them in with my goodies and post to you.