Hi all, i just installing alarm and also i have power window module, Just wondering if anyone has added an automatic power window module to their Zed? I'm in the process of installing one but don't know which particular wires operate the power windows. I need to know which wire for each side operates the windows to go up. And where the closest point to access this wire is Thanks Anthony
i put mine in the drivers door, the only PITA is you have to run a constant 12v wire into the door to power up the module, I dont remember the wire that i used for the passenger side but for the drivers side i just traced the wires from the motor back to the window switch, the easiest way to find the passenger one is to use a test light on the wires on the back of the switch and find out which one sends out power when the switch is in the up position and then just cut into that wire. Probably might be an idea to put it into a balloon or a plastic bag though if you do decide to put it in the door as some water does get into the inside of the door and as it turns out electronics dont like water , I didnt and I need to buy a new module.
mate, where did u run the wire for module, is that on the switch or on the black box amp? i have 3 wire from alarm and feed to door a ready just need the wire for power window up.. thanks
I ran the wires to the back of the switch, from the module that I had, I had 2 wires for each window and you have to cut and join the wires inline with the wire that goes to each window, and the power wire I just ran a separate wire through the door grommet straight from the back of the ignition switch and then obviously a feed from the door so that it knows when to go up.
