Hi all, had my old hose replaced by enzed and they got it wrong (this sh*t can only happen to me ). They put a bolt on the banjo end that is to big, so the banjo does not sit flush on the p/s unit. I took it back and the guy took to it with a bench grinder (trusting him on this), it helped a bit, the banjo fitting at least sits parallel to the p/s pump (about 2mm). I will take it back next week for round 2, but I need to know what size the bolts are meant to be. Has any one got one they can measure with a vernier guage. The sizes I want are marked with arrows in the below image (the one on the left has been ground round): I can only hope the actual length of the hose is correct. any help appreciated.
