Keyless entry blinker help

Discussion in 'Technical' started by kakaboy, Jul 16, 2013.

  1. kakaboy

    kakaboy New Member

    I have installed keyless entry and I would like to hook up the blinkers .

    I have two wires that says to connect to the left and right blinker circuit .

    Where do I find this ? I know where the blinker relay is under the dash can that be used ?
     
  2. sevenangrypenguins

    sevenangrypenguins Active Member

    i used wires on the hazard switch.
     
  3. jamersss

    jamersss Member

    Did this the other day during my alarm install.

    In the climate control pod, there will be a light green and dark green wire with a yellow trace going to your hazard plug. Splice into both those wires and you'll be sweet ;)

    I also re-call the same wires existing under the steering column however they are taped up and may be harder to splice and wire too.

    I hope this helps!
     
  4. kakaboy

    kakaboy New Member

    I wonder if these wires go down to the relay . Ill have to check wiring diagram .
     

Share This Page