I am about to make some moulds for a pair of speaker pods, but i require some inspiration. if anyone can point me in the direction of some pictures i would greatly appreciate it If all turns out ok it's possible i can make multiple sets if there is enough intrest Cheers Peter
Hmmmm not bad Thanks I might leave out the tweeter though but leave a flat spot for embeded tweeters if need be
I am hopefully starting this weekend time permitting I am going to shape them in some 2 pak HD Foam and then make a mould from that not too sure how much they will cost Dont know what is reasonable for something like this?
Door Pods Update 1 Here is the progress of the door pods Any suggestions/modification ideas while i can still do it easily I Should have a mould of the drivers door Possibly Tuesday Cheers Peter
nice work if you ever decide to produce more than one, i'll take a set off your hands. if you sell them you could make a buck or two. :thumbsup: ash
Dont Worry I will be if the moulds turn out ok i will be posting pics of them when they are completed they suit 6 1/2 speakers. I'll put it in the group buy section if the moulds turn out ok (even if they don't, I'll just start over). I'll also try and figure out the price of materials over the next few days as I get it done. Any ideas you think should be incorporated into the design? What do you think about the recessing of the speaker? Good idea (to prevent catching legs on speaker cover) or bad idea (may not fit every speaker perfectly)?
might need to recess speaker > if you can hold the foam to the door see how much room there is for feet open and closed. might be interested in a set myself..
nice >> my infinity kappa's would look good without the grill on in a set of those :thumbsup: how were you looking at attaching them to the door??
Well Quite possibly the standard mounting holes, a fully backed pod that screws on through the standard speaker grille holes. It may need one extra screw to hold the furthest end steady. I'll figure it all out once I've got my mould done, but that looks like the most likely way.
Door Pods Update 3 - Gelcoat Well as you can see the gelcoat is finally on after a lot of bog and sanding. Tommorow i will hopefully have the mould For the drivers side completed Then its on to the passenger Side
More Pics The mould for the drivers side is almost done just a bit of sanding and testing and then it's on to the left side
