VIC Getting rid of all my Z gear PART1, some free stuff

update + price reduction


OEM throttle cover - $15
Throttle cover painted red with silver nissan font - $10


stock indicators in good nick - $15 pair
drivers window switch - $10
pass window switch - $10
mirror switch - $10
rear wiper motor - $30
front bose speaker housing RHS - $10
flares - SOLD
dash pod + housing - SOLD
antenna - SOLD


side splash guards $10 each
RHS wheel arch guard - $20


auto shifter complete assembly - $20
unifilter (airpod) housing with maf adapter (needs new foam filter) - $10
ignition control unit - $20
good auto trans mount - $20
front + rear wipers - $30 set


working FPCU - $50
working AUTO ECU - $40


4 bolt tuneagent split dumps with 1 near new o2 sensor - $80


drift air filter with maf adapter - $20


driveshaft shield - $5 each




driveshaft with what looks like a recently replaced center bearing and good uni joints - $60
driveshaft with good unis needing a new center - $30


stock pre cat exhaust in good nick - $40




2001 rear Klippan belts retract like new - $60
2001 front Klippan belts retract like new - $100
Polished rad pipes, missing 1 temp sensor - $80











Stripped Short block in very good nick, returned high comp across all cylinders was going to use this as base for a power build. Includes block, crank, pistons, rods, oil pump, sump, heads - $300




Manual conversion kit, includes everything pictured; gearbox, pedals, master + slave cylinders, clutch booster, used clutch + press plate, oem knob + boot, shifter - $850


socketed ECU, tested and fully working, no EPROM (missing some case screws) - $80 each


pocket romulator + cables and software. - $80 Had this running for about 3 years in my car with no problems http://secure.transtronics.com/osc/p...roducts_id/328


williem EPROM programmer, cables + software - $20


Nistune Full software license - $100

 

Hi Tony

Still got the block and heads?

 

I will take the tuneagent split dumps, i will pick them up tonight.

 

Thanks Mate, Parts arrived today.

Infill Panel broke in 2 more places but that was to be expected. Thanks for the good wrapping you did! Would be in about 20 pieces if you hadn't I think!

Cheers,

Adam

 

I tried my best to make it Austpost proof mate

 

engine and dumps now gone

 

sorry to be a pain but are you willing to seperate pod from maf adaptor?

cheers

 

Hey mate do you know what condition your manual gearbox is in?

 

gear box shifted well, have not stripped to inspect though

 

Hi Tony
The PTU arrived last night.
Fitted it this afternoon.
Works well on all 5 cylinders, just wish I had 6 No4 not working.
I had cleaned all contacts before fitting to eliminate a dirty contact, so can only come to one conclusion.
I know the answer is going to be "It was working when it left here"
Oh well, it'll make a great $20 paper weight.

 

Yeah I had it running in my yellow zed for years with no problems but if you're convinced it's the PTU send it back and I will refund, np

 

pods

hey mate if u still got the interior pod for the RHS and the control unit for it pm me a piccy please, i need a new one, also LHS too if u got the climate control one

 

Hi Tony, I'll take one of the socketed ECUs, please check your PMs.

-Martin

 

I sent you a pm a few days ago and still no reply???

 

update

OEM throttle cover - $15
Throttle cover painted red with silver nissan font - $10
stock indicators in good nick - $15 pair
mirror switch - $10
rear wiper motor - $30
front bose speaker housing RHS - $10
side splash guards $10 each
RHS wheel arch guard - $20
auto shifter complete assembly - $20
unifilter (airpod) housing with maf adapter (needs new foam filter) - $10
ignition control unit - $20
good auto trans mount - $20
front + rear wipers - $30 set
working FPCU - $50
working AUTO ECU - $40
drift air filter with maf adapter - $20
driveshaft shield - $5 each
driveshaft with what looks like a recently replaced center bearing and good uni joints - $60
driveshaft with good unis needing a new center - $30
stock pre cat exhaust in good nick - $40

Come and take to lot for $200




2001 rear Klippan belts retract like new - $60
2001 front Klippan belts retract like new - $100
Polished rad pipes, missing 1 temp sensor - $80


Manual conversion kit, includes everything pictured; gearbox, pedals, master + slave cylinders, clutch booster, used clutch + press plate, oem knob + boot, shifter - $1200

Im after more for this now as I have opened the gearbox and confirmed very good condition. No rust or chips on any of the gears and all the synchros / dog teeth are showing minimal wear. More pics of gearbox and clutch below.

 

Hi
You still got the foglights for sale
Let me know
Thanks
Caz

 

I have pm'd you regarding manual conversion with no reply!

 

I PM'd him regarding parts on the 26/03, also awaiting reply.

 

Please re-send pm I accidently deleted my entire pm box a while back so might have missed it.

 

update + price drop

OEM throttle cover - $15
Throttle cover painted red with silver nissan font - $10
stock indicators in good nick - $15 pair
mirror switch - $10
rear wiper motor - $30
front bose speaker housing RHS - $10
side splash guards $10 each
RHS wheel arch guard - $20
auto shifter complete assembly - $20
unifilter (airpod) housing with maf adapter (needs new foam filter) - $10
ignition control unit - $20
good auto trans mount - $20
front + rear wipers - $30 set
working FPCU - $50
working AUTO ECU - $40
drift air filter with maf adapter - $20
driveshaft shield - $5 each
driveshaft with what looks like a recently replaced center bearing and good uni joints - $60
driveshaft with good unis needing a new center - $30
stock pre cat exhaust in good nick - $40

Come and take to lot for $150




2001 rear Klippan belts retract like new - $50
2001 front Klippan belts retract like new - $80
Polished rad pipes, missing 1 temp sensor - $60


Manual conversion kit, includes everything pictured; gearbox, pedals, master + slave cylinders, clutch booster, used clutch + press plate, oem knob + boot, shifter - 1K









[/QUOTE]