Does anyone know these three resistor values?

Discussion in 'Technical' started by angrybear, Aug 20, 2008.

  1. angrybear

    angrybear Moderator

    Messages:
    1,212
    Likes Received:
    21
    Trophy Points:
    0
    This is the taillight sensor circuit, which has had a bit of a problem as you can see. Smells as good as it looks.:D

    [​IMG]
     
    Last edited: Aug 20, 2008
    angrybear, Aug 20, 2008
    #1
  2. Hyper101

    Hyper101 Well-Known Member

    Messages:
    2,907
    Likes Received:
    29
    Trophy Points:
    48
    Are the bands that far gone that you cant see the colours ? Hard to tell from the pic
     
    Hyper101, Aug 20, 2008
    #2
  3. Chrispy

    Chrispy Pretentious Upstart

    Messages:
    12,888
    Likes Received:
    368
    Trophy Points:
    83
    Far out, never seen one actually burnt, only ever a dry joint :eek:

    Can you read the colours?
     
    Chrispy, Aug 20, 2008
    #3
  4. aazn

    aazn New Member

    Messages:
    1,981
    Likes Received:
    6
    Trophy Points:
    0
    stop being lazy and pull the board out of ur cars...
    i cant pull mine out coz i dont have it :p getting a new clutch in it
     
    aazn, Aug 20, 2008
    #4
  5. Hyper101

    Hyper101 Well-Known Member

    Messages:
    2,907
    Likes Received:
    29
    Trophy Points:
    48

    err im at work
     
    Hyper101, Aug 20, 2008
    #5
  6. Chrispy

    Chrispy Pretentious Upstart

    Messages:
    12,888
    Likes Received:
    368
    Trophy Points:
    83
    It's dark and cold outside :rolleyes:
     
    Chrispy, Aug 20, 2008
    #6
  7. aazn

    aazn New Member

    Messages:
    1,981
    Likes Received:
    6
    Trophy Points:
    0
    yeh so what if ur at work.. when i was working at honeywell.. i made a multimeter...
     
    aazn, Aug 20, 2008
    #7
  8. angrybear

    angrybear Moderator

    Messages:
    1,212
    Likes Received:
    21
    Trophy Points:
    0
    One is completely charcoaled.

    On the other two I can see the top two bands, both orange = 22, but no chance of identifying the multiplier or the tolerance bands. I'll try a toothbrush :D.

    This unit came from mikemd's car and I had a good one for him that I passed across today without looking at it. I was going to cross check this crook one with the one in my grey Zed but I find that car has been rewired back there to remove the sensor completely. I then checked my blue zed and guess what? that one has been excised as well.

    For all the trouble these little boxes cause (such as Ali at WSID recently) perhaps rerouting a few wires to remove them seems a good idea.
     
    angrybear, Aug 20, 2008
    #8

Share This Page