Diff bushings

Discussion in 'Non Technical' started by BiGZ, May 7, 2011.

  1. BiGZ

    BiGZ Iridescent Member

    Does anyone know if the metal case inside the diff bushing on the rear subframe is interchangeable between na and tt?
     
    BiGZ, May 7, 2011
    #1
  2. Mitch

    Mitch Has one gear: GO

    I can get a diameter measurement for you from a NA subframe if someone can get one for a TT.

    Video of pressing mine out below :cool: :
    [yt]VVdZJPnF8C8[/yt]
     
    Mitch, May 7, 2011
    #2
  3. sevenangrypenguins

    sevenangrypenguins Active Member

    I have a stripped TT frame I could measure when I finish work.

    Not sure what you mean by metal case though.
     
    sevenangrypenguins, May 7, 2011
    #3
  4. BiGZ

    BiGZ Iridescent Member

    the inside piece of the bushing
     
    BiGZ, May 7, 2011
    #4
  5. Mitch

    Mitch Has one gear: GO

    I'm not sure if I still have the bushing that I pressed out in that vid... but Its a tight fit. Maybe one of the mechanical engineering speople out there might know what tolerances constitutes a 'tight fit' and my resulting ID of the subframe bushing 'hole' can be modified accordingly.
    OR sevenhelpfulpenguins can measure the ID of the subframe and we can compare vlaues. :zlove:
     
    Mitch, May 7, 2011
    #5
  6. Zano

    Zano Member

    These vids are a big big help. A great walk through.
     
    Zano, May 7, 2011
    #6
  7. sevenangrypenguins

    sevenangrypenguins Active Member

    My bushes are gone as well so can only give subframe diameter. I cut mine out, didn't take long for the diff bushes.
     
    sevenangrypenguins, May 7, 2011
    #7

Share This Page