Hi guys, I have just done full data monitoring on my Z and here is the results not sure they are good or bad. I can see coolant temp is going high stock intercoolers I have just install after market 4 inch pod filter so air flow should be good but i forgot to do it before i install this. Does anyone running stock air filter and know what there reading is? I do have code 34 knock sensor issue which i need to bypass
TPS is slightly out so is your base idle only just. Do a screen shot with "Full Data Monitoring" so it shows everything. EDIT: that's full data monitoring? should show both your O2's ect not just one. Another good test with that is the "Power Balance test"
Nothing wrong with your coolant temps, not even fully up to operating temperature yet. Should normally sit between 80-90 degrees though anything under 100 is perfectly fine. TPS appears to be out 0.02v but that isn't enough to even worry about.
the first image is of full data monitoring. I think my software is not a full version that's why i can't see second 02 sensor? I don't have "power balance test option" highlighted any one know the trick for that? geeks ?
Ohhh the non-tuner version? I think... the free version of Data-scan shows both. On topic, with that base idle thing while its open you can go ahead and adjust the idle screw to bring that arrow up in the green. Close that idle window and you're done without unplugging the tps.
Unplug them and use a multimeter? To be honest I think paying for Datascan is better and cheaper if all you want are engine readings.
Its just the angle of it. Its really close, hardly needs adjusting but if you want something to do then loosen the bolts upper and lower bolts holding the sensor to the side of the plenum, adjust by tilting the sensor up or down. I'd just leave it cos .44v is correct.
