Hi guys ok Changed plugs checked coils. ran conzult thanks again CAZ no problem but Zed still has a cyl going down at 2500 approx revs ( this is a pain due to 110 klms at 2500 rpm) pour on the gas and its fine drop it back a gear and it powers great cruise at 2500 errrrgggggg pop gurgle splutter ( l did notice wierd readings on one of the 02 sensors) but whats wierd ....lm still learning 02 sensor in ztalk diag has the needle going haywire whats that mean ?????????? buggered if l know lm still learning ANY Guess's and could it be air mix ??????? errrrrrr HELP regards Geoff
Sounds like your afm is playing up, try cleaning up the connector, if that dosen't help the hot wire is shot inside the afm, which means the ecu is reading screwed afm, and wont let you rev over 2500rpm. Swap over with a working afm to be sure.
conzult Thanks mate l'll borrow the one out of the wifes zed and try it would that show up on the conzult ?? regards Geoff
Never used conzult But i would think so! Do you still have the S1 ptu, if its not the AFM, you may want to swap over the PTU from the wifes Zed. Good luck! Geoff.
if the AFM has given up the ghost or the plug has then you will recieve an error. code 12 is if the afm circuit is shorted or in complete.
while she aint lookin Ok l'll swipe a few things off the wifes Zed while she's not looking ....ummmm l'll tell her the brake drums scrapping on the tailshaft or something hee hee regards Geoffviper
