Hey guys, I've got some spare time coming up soon so am going to replace the centre bearing on the driveshaft...as the current one is rooted... I have thoroughly read through the write up in the tech section, and my dad are going to do the swap...ass end up on the ramps in the driveway... My question is...is there a specific torque that the nut on the shaft needs to be tightened to? I have access to a torque wrench but just want to know what the right torque is first. I know it's spline, and must be lined up perfectly as it's balanced etc etc. Any other tips would be great... Cheers Matt
Correct torque valves will be in the factory service manual. I'm sure John will post the relevant page
Yep just looked at online manual after i posted the realised...245-294 Nm... Sorry for pointless thread! Thanks.
"Give a man a fish and you feed him for a day. Teach a man to fish and you feed him for a lifetime." My manual posts are about showing good fishing locations, how many have read or a good browse from front to back ?
