Any1 done or where 2 do polished throttles? (n/m)

Discussion in 'Technical' started by TIMID, Mar 30, 2004.

  1. TIMID

    TIMID New Member

    Messages:
    61
    Likes Received:
    0
    Trophy Points:
    0
  2. chewy

    chewy Active Member

    Messages:
    2,647
    Likes Received:
    17
    Trophy Points:
    38
    yep - did them myself and took me

    about 1 week each day to do 1 throttle body though I did grind a lot away from the existing design. I removed all the webbing, removed the water pipe underneath completely. Cut a recess area in the vacuum pipe outlet so that stainless t-bolt clamps fit on properly. Don't touch the insides of them as the butterfly plate will not seat properly.
     

Share This Page