300zx Stalling/Cutting out Whilst Stopping/slowing down!??

Discussion in 'Technical' started by AILD97, Dec 7, 2014.

Page 2 of 2
  1. East Coast Z

    East Coast Z Well-Known Member

    Depends....

    .......on whether it's a TT or NA.

    A TT Auto is specified at 750rpm + or - 50rpm.
    So it could be anywhere from 700 to 800rpm.

    Whereas an NA Auto is specified at 770rpm + or - 50rpm.
    So it could be anywhere from 720 to 820rpm.
     
    East Coast Z, Dec 14, 2014
    #21
  2. AILD97

    AILD97 New Member

    Ahh no worries thanks for the info then.
     
    AILD97, Dec 14, 2014
    #22
  3. Tony

    Tony Member

    FICD

    Yes you are correct the FICD idles the car up slightly when Air Con is ON.
     
    Tony, Dec 14, 2014
    #23
  4. AILD97

    AILD97 New Member

    Well mine is obviously stuffed then!
    Hopefully if I replace it my car should be running properly again

    Thanks.
     
    AILD97, Dec 14, 2014
    #24
  5. munted

    munted New Member

    Prob check the connectors for the IACV and ficd ain't swapped around.
    I may have done it in the past so I know it's possible :p
     
    munted, Dec 14, 2014
    #25
  6. AILD97

    AILD97 New Member

    Hahahahah! It happens i guess? Ahaha
    I can certainly 100% say they are in the right spots as i did them one by one (took one off cleaned then put it back) and my Z hasn't always been like this..

    However I wish it were that and it was that simple
     
    AILD97, Dec 14, 2014
    #26
Page 2 of 2

Share This Page