Chasing TT Manual Gearbox.
Free z parts. Pickup only. Mostly turbo and non turbo hard pipes, AC box, balance bar, fuse box cover etc. check photo. Must take all. Must be...
Another funny issue with the car which I came across recently and took me an week to find out what was wrong. Intermittent fuel pump prime failure...
I have a CAS series1 as spare in working condition. Bought few months ago. Can't use since I have series two connector. I need series 2 so this...
Just did a test and no continuity between G and 1,2 ,3, 4, 5, 6...
I have started to use 10% E10 unleaded 95 recently about 6 weeks ago and having cold start problem in the morning. And it is getting worse every...
Need bit help with right tool what to buy? Need replacing pads and pushing back piston isn't very easy using C- clamp from bunnings. Any better...
After few attempt with southbend clutch there is no luck. Chris replaced throwout bearing with stock carrier. Still can't engage gears when car is...
After everything has been done now I am stuck and not sure what did wrong? Clutch fork is sitting in middle. It supposed to push the rod back all...
Stuck again. Need some ideas before I damage my clutch fork assembly. Southbed came with new bearing. But can't pull out old OS giken bearing ,...
Never knew there was a version called ladybird....
Time for new clutch. Decided to go for either full face or 6 puck but like to know opinions if anyone has used any of the clutch below and which...
Since I moved to full 3 inch twin exhaust I don't need 2 X Magnaflow 14807 and UAS 2.5 inch mild steel resonator from rob260's GB. Local picup...
Interesting 6.7L Twin turbo package for sale in perth. Not sure if LS1 would fit in Z engine bay. But looks it is going to be an interesting...
Stock rear bumper has to go. Very good condition. No crack or scratch. $120 pickup. [IMG] [IMG] Rear side marker lense with superbright...
I am planning to upgrade my exahust very similar to Felix's system. Sorry I can't remember his name. I couldn't find any 3 inch inlet Dual tip...
[IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] Parts used [IMG]...
Few spare bits kept as spare...but need some extra cash. Working S1 CAS from my old motor. [IMG] $100 plus post. Working S2 PTU with...
Decided to go for ashspec in tank dual pump setup. Not interested to move the battery in boot. All has been tested and working onder and used for...
Not sure if repost but very interesting....
Separate names with a comma.