You can run the NA pinion on the TT sensor without swapping the sensor because the offset is not large enough to be an issue according the some of...
Definitely don't be trying to increase the boost via EBC while you have a bunch of other issues going on. ~7 psi is what you should expect to get...
The idea of this car returning to an unmolested state is a bit pine the sky.
Averaging the AFM signals should be ok no? I can see the issues with adding the two voltages together because the exponential VQ table would cause...
Autopia.org was always the place for detailing. Zaino and Menzerna were well regarded when I used to spend time there.
At that power level I'd go full 3". http://www.twinturbo.net/nissan/300zx/forums/general/view/2033426/3-inch-parts.html Crucial points. Stock...
Don't have the service manual handy but might be in the EF section.
Passenger side, SZ 4-bolt for reference: [IMG]
+ the likely increased unsprung weight which can cause higher stresses and changes to vehicle dynamics which the manufacturer has not designed...
Which is further away from the standard rolling diameter than the size i mentioned just like I said. :rolleyes2::rolleyes2::rolleyes2::rolleyes2:...
~0.4" Be aware that there are very few tyre manufacturers that actually make tyres in 285/25/20. There really aren't that many making tyres for...
Rolling diameter is like 10% off standard no? 285/25/20 is about the closest available diameter for 20s.
Wheel width is measured inside bead flange to inside bead flange, not outside to outside just in case you're measuring outside. Think you had a...
Separate names with a comma.
