in relation to this particular little beastie, i found that someone had wound the screw so far into mine that instead of the ECU controlling the...
http://cgi.ebay.com/ebaymotors/Nissan-OBD-USB-datacable-consult-240SX-300ZX-Maxima-_W0QQcmdZViewItemQQhashZitem230964b515QQitemZ150481450261QQptZMo...
These are good places to start and can be done with some basic tools. grab some hose and get listening for vac leaks. short of that find someone...
HAHA very hard to be missed with stupid plates like mine
Funny you should mention that considering i bought mine for less than 5k. apart from things that wear out like a tailshaft and the plenum hoses it...
1 piece tailshaft is the way to go. by the time you screw around replacing the bearing you will probably find that the uni joints are stuffed.
$625 fully comprehensive with sgio. i didnt have a crash for like 4 years so i now have a lifetime 65% no claim bonus. being a p plater fully...
haha, yeah i remember that, did you have your plates on the dash?
Blue zed about 12:30 parked in front of the IGA on royal st East Perth
sick... now you can start to enjoy the car...
mine did a lot of that, was the rear trans mount flopping round like a bastard
cheers mate, heineken is going down a treat... :D
initially there was no movement, possibly because it had cooled down. however after a couple of minutes after i jumped it there was movement when...
what sort of clunk, when does it occur?
gday guys, Just went and met Jordz and had a look at his car. Plugged it into my laptop and there isnt a single sensor fault...
Separate names with a comma.
