slightly modified the sump thisarvo will be putting some wings on it to give it a bit more oil volume.
How will this effect the oil capacity and also the possibility of decreased flow rates? edit - didnt see wings, but would still like to know the difference in volume/flow rates
there is heaps of room between the oil full level and the scraper so you could just put a little more oil in. but wing will look cool to
There is a reason it leaked....YOU WELDED IT hahahahha You miged your vh sump yea? I usually tig the outside first then mig the inside.
Nice progress. So who is doing the fab work here? I assumed you were, Chris (ezzupturbo). But on 3ZC, Romonski is saying he has done the work Either way, I like it
Yeah, MIG'd it. Leaked like a bitch so got a ally one made (didn't fit) so got someone else to make a steel one for me and even that weeped a little bit. Oil impregnated steel, always hard
sumps welded snug fit but everything clears by a fair bit will dye pen sump once wings welded on shouldn't leak to much good penetration
put some brackets on cooler so i can start the pipe work got rid of that stupid trac control run harness through firewall(was going to run through ac hole) modified some water hard pipes made provisions for 3" cooler pipework