Not sure what it is called but the bit where the petrol cap screws into has came out when filling her up the other day 300ZX 2+0. The 2 little...
It seems there is a problem with this car. It should be easy to spot. link
I have had problems with my water and methanol injection jets blocking up because of what would appear to be calcium build up or something like...
My car has started making an intermittent buzz noise from the under the dash area. Any ideas what it could be? I have removed all of the panel...
For sale is the ECU out of a 300ZX TT 09/1993 2+0. The ecu has a big RL on it and is in excellent condition. Asking $160 including postage within...
I have just installed a wide band 02 sensor and are getting very high AFR readings at idle. I am thinking that the readings are faulty at idle. Is...
I am trying to find information on the electrical connection of the temperature sensors after the catalytic converters. Where do they connect into...
I am after the colour codes of the wiring connections to the ECU. Specifically I need the speed sensor and RPM sensor wire colours.
I am after information on the supply voltage and output voltage (or current) of the boost sensor. My in dash boost gauge does not work so I can't...
Any ideas on what wire to use inside a fuel tank? The shielding on standard type wire may or may not be fuel resistant? Where is fuel resistant...
I have'nt found much if any discussion on the in tank fuel damper and if it can safley be bypassed with a good fuel pressure regulator in place....
Anyone know where I can find a clear (as in legible) copy of a Z31 (1994) wiring diagram? In particular I am looking at the injector wiring.
I have built an electric circuit to average the output of two z32 AFM's consisting of one op amp chip and and a couple resistors and I want to...
I have this fuel pump (UNISIA JECS A42-622B37 0524) that is meant to be good for 700hp. It is similar to the original 300ZX TT seriesII fuel pump...
I have after market BOV's that vent into the atmosphere but I am looking for a 45Deg and a 90Deg elbow to vent them into the standard intake...
Separate names with a comma.