Rear wing taken fro 1990 ZX - used but in good condition. Red in colour. Sits about 200mm - 250mm off the back of the car. Located in Northern...
For Sale - Rear Wing for 300ZX Used but in very good condition Sits about 30cm off ground so would sit about 25cm off bare boot. Colour: Red...
Serial conzult cable in good condition with software and service manual on disk. $80 posted.
Price: $12,000 2 + 2 Targo top 100,000 km geniune with log books Excellent mechanical condition, timing belt replaced Very good body Colour:...
I've just had a strange thing happen. Whilst driving the Z the overdrive and OD light stopped working. Then I noticed that all the gauges were...
For anyone thinking about removing these system I have done so with no apparent effect on performance. I can't notice any difference after the...
I planning to buy and install a fairly standard radio/CD player in my ZX and was wondering whether there's anything unusual about relacing the...
I'm about to replace a rear wheel bearing and read some threads that warn me about some difficult areas such as: 1. the main centre nut is...
Is there a way to have just the ventilation fan running without the climate comtrol air conditioning running? At the moment I've been setting the...
There's an article in the technical section explaining how to alter the wiring so that the auxillary fan is on whenever the aircon is on....
May be a dumb question.....Is there a greater load on the aircon and hence cooling system using the high fan speed rather than the low speed or...
as I turn the streeing wheel. Its on when the car interior is hot and only when turning the steering wheel. Any ideas about how to stop it such as...
I remember reading some time ago about where to buy a converter for the ZX radio so that it picks up the Australian frequency band but I can't...
TTZ have them for $45. Has anyone bought one and has comments on them? Has anyone had success with other sources of supply? I want to cover some...
My engine was saved by the TWD yesterday - worth its weight in gold! It warned me of the car boiling while the temp guage stayed on normal. But...
Just confirming all the good advice I had from the forum: I've had a problem for a few weeks with the car stalling and then a 2,500 rpm...
You may remember my post a couple of weeks ago about the car stalling occassionally and not being able to rev past 2,500 after the stalling....
I'm about to send my AFM away for testing and possible replacement but I'd like to check the resitance values against any good units. Has anyone...
I'm pretty well convinced now that my engine cutout problem is related to the AFM. I ran Conzult again after fiddling with the AFM and I'm getting...
Further to a previous post I still have an engine cutout problem after a top end rebuild. The car starts easily and runs really well but just cuts...
Separate names with a comma.