If auto I think you can replace the heater core without removing the dash. Mine was a manual so had to remove the dash as the clutch assembly gets...
Replaced the Bastard hose. I can tick that off the bucket list now
Check the pins don't push out of the piggyback adaptor harness as the adaptor plug housing doesn't seem very strong
Got two forward facing kids seats in mine. Have towels under the seat also to pack it up higher & not destroy the seats. Girls are six now and...
Try measuring VN Commodore boots. Fairly sure that's what I used a few years back
+1 for the KU36. Really good in the wet and dry. Might be a bit too soft if doing a lot of km's though.
Flip the circuit board out of the black plastic casing. When you look at the bottom of the circuit board where the pins go through you will be...
For low volume production runs try contacting: www.mocza.com. They do all sorts of unusual moulding & casting.
The Toy Black300zx has one of these in his car. It's a 2+2 TT auto, 89 I think.
Dry solder joint ? Could it just be a dry (cracked) solder joint that resoldering will fix ?
I found a 1 yen coin under my drivers seat a year a year ago. Was thinking of making a key ring out out it.
Separate names with a comma.