WA MODDED Z32 PERFORMANCE PARTS & SHELL

Up for sale is my entire collection of Z32 stuff. This is all the stuff from my car, which is being stripped down this week.

PM me for specific info. Parts located in Wangara, WA and can be inspected by appointment during business hours. I can also be contacted by phone on 0418822444 with caller ID. Dont waste my time with stupid offers etc, and please post only if it's relevant. Pics supplied to interested parties.

There's more, I'm sure. Thanks.

Rolling Shell 1990/91 2 Seater $3500
Painted in Nissan Blue-ish Green (factory colour for the Pintara in about 1990) Was black. Paint faded but in good condition otherwise. Fitted with green compliance plate and is currently unregisterred. It is complete minus the parts listed for sale below. Hicas removed - lock bar, PIAA low beams, Laserline Alarm, No Stereo, radiator or front bar.

Nismo speedo $300
300km/hr

Engine with Upgrades $3,500
New cam seals, rear main seal, front seal etc etc, New water pump and all hoses (silicone on the head bypasses) new thermostat, new timing belt, spark plugs etc as per 100,000k service, Modded PCV set-up and Breathers (no oil in plenums!!), Ported Exhaust manifolds (ceramic coated), Rebuilt/matched pair T25G turbo's (ceramic coated)
Has never been run since work done. All upgrade parts are still NEW.

4inch Trust Single system - Cat Back $900

BORDER front mount cooler and pipe kit - $2200.
Brand new never run, but has been installed. This is THE BEST KIT you can buy. Cost me over $4k to buy new.

Twin intakes (in original intercooler position) $500
Has twin 6" JWT POP Chargers and requires either aftermarket ECU or remapped stocker. Piping made from 3" stainless. Cleaners have been used for a while when I had side mounts but the whole conversion itself has not been run.

Intercooler to Intake Pipes $300
Polished Stainless steel with siliconehose. Replaces those old shitty rubber things.

BRAND NEW engine wiring harness $800
genuine nissan, still in box.

OS Giken twin plate clutch'flywheel $1200
Excellent condition, no typical wear/abuse. Has reshimmed fingers.

Manual Conversion $2500
5 Speed box with shifter, new shifter bushings, new clutch master and slave, clutch booster, pedal, custom 1 piece (2 seat) tailshaft, crossmember etc, NO CLUTCH. Comes with nuts bolts etc ra ra.

Whiteline sway bars $200/pair
This is the 1st set they ever made. Has Poly D bushes buy no end links. Brand new but have been fitted.

RG Racing Gear Coil-overs JTC N1 $2000
Again brand new, but fitted. These are the (at the time) top spec damper that RG made. Have excellent spring and damping rates. Will not disappoint. Worth over $3500

Recaro SR buckets - Pair $1000
Excellent condition. Includes drivers side rails. Black with the multi coloured flecks.

R32 GTR front brakes $500
Painted calipers (black), good pads, good rotors, surface rust

Volk 17x8/9's with 235/255 tyres $800
Yeah, average condition. clean up OK. Tyres knackered from age but are still round and black! No centre caps.

 

Do you reckon you could find out the postage cost to 2600 act for the sway bars?

 

pics of the rims? or email then to ben@toyer.id.au?

cheers

 

pm sent regarding recaros

 

Also interested in the rims, please send pics to hypo_gurly@hotmail.com

 

Any chance you would be interested in seperating the gear box? If so please shout out.
Thanks.

 

pm sent about speedo

 

Thanks to all for the interest so far. Will respond to the PM's shortly.
To those that have been in to see the car, most of the parts have been separated now and I will be taking photo's tomorrow.

 

Answers to some common questions:

The car and all parts are located at 30 Automotive Drive, Wangara. Ask for me, as this sale is private and nothing to do with the business operating at this address.

Within reason, the prices are pretty fixed, unless you plan on buying a bit of stuff in which case I'll show some grace.

A few people are keen on the sway bars from interstate, but to be honest, the cost of postage is a little prohibitive and there is enough local interest regardless.

To avoid delay with replies to messages and such, it's best to call me. If I miss your call, just sms me. It's hard to hear the phone on the dyno some times!

 

If you can still edit your post, I would remove your address or PM a mod to do this..

 

hey dude, im still keen on the recaros.
are they the Oem reclinable units ??
thanks mate.
hit us back

 

Interested in manual conversion parts

Will pm you both, if JB wants the box I might be interested in taking the rest excluding the tail shaft as I have a 4 seater.

 

Sway bars long gone. Thanks.

I also have

1 set of coil-packs, excellent condition $200

Standard ecu, suit remapping, replacement whatever $200

Aluminium crankshaft pulley, brand new, which I had hard anodised $150

1 set of brand new fan belts, genuine Nissan $50

R32 GTR rear brakes - painted (black) calipers, good pads and good condition slotted rotors $250

Brand spankers AFM, no box $200


Open to genuine criticism if my pricing is out of control, but I DONT need to sell the stuff, I WONT give it away.

 

Wiring Harness

 

Coilovers

 

GTR Front Brakes

 

Fanbelts

 

ECU

 

Coilpacks